A Novel Single Step Border Molding Technique using Conventional Low Fusing Impression Material – A Clinical Tip

B. Esawaran Esawaran; kanmani R

doi:10.55995/j-cpi.2021006

A Novel Single Step Border Molding Technique using Conventional Low Fusing Impression Material – A Clinical Tip

Authors

B. Esawaran Esawaran Associate Professor, Dept of Prosthodontics and Implantology, TMDCH, Dr. M.G.R. Educational and Research Institute, Chennai, Tamil Nadu
kanmani R

DOI:

https://doi.org/10.55995/j-cpi.2021006

Abstract

A simple technique has been described which uses a conventional low fusing impression material, for border molding of complete denture impressions. It has the following advantages: 1. Border molding of the entire peripheral regions can be accomplished in a single step. 2. More controlled dispensing of the green stick compound around the periphery. 3. Corrections if any, for specific areas can be redone with ease. 4. This technique is easily mastered.

Downloads

Published

2021-06-30

How to Cite

Esawaran, B. E., & R, kanmani. (2021). A Novel Single Step Border Molding Technique using Conventional Low Fusing Impression Material – A Clinical Tip. Journal of Clinical Prosthodontics and Implantology, 3(1), 1–30. https://doi.org/10.55995/j-cpi.2021006

Download Citation

Issue

Vol. 3 No. 1 (2021)

Section

Short Communication

License

The entire contents of the Journal of Clinical Prosthodontics and Implantology are protected under Indian and international copyrights. The Journal, however, grants to all users a free, irrevocable, worldwide, perpetual right of access to, and a license to copy, use, distribute, perform and display the work publicly and to make and distribute derivative works in any digital medium for any reasonable non-commercial purpose, subject to proper attribution of authorship and ownership of the rights.