Wavelength dependent photosensitivity modulation of Aluminium/Lead sulphide/Indium tin oxide back-to-back diode

Abhijit Banerjee

doi:10.52756/ijerr.2020.v22.001

Authors

Abhijit Banerjee Department of Electronic Science, Acharya Prafulla Chandra College, New Barrackpore, Kolkata-700111, India

DOI:

https://doi.org/10.52756/ijerr.2020.v22.001

Keywords:

Aluminium/lead sulphide/indium tin oxide, Back-to-back diode, Current-voltage, Capacitance-voltage, Photo-sensitivity

Abstract

The photosensitivity of aluminium (Al)/lead sulphide (PbS)/indium tin oxide (ITO) thin layered structure is investigated considering the photon wavelength dependent current-voltage and capacitance-voltage characteristics of the device. The current-voltage characteristics of the test structure are analyzed adopting the back-to-back Schottky barrier diode model. The diode possesses low dark current in contrast to the high value of photocurrents measured under different illumination wavelengths. The change in photocurrents with different illumination wavelengths clearly indicates the change in photo-sensitivity of the device. The capacitance-voltage characteristics of Al/PbS/ITO structure demonstrate a definite improvement of the device capacitance with the higher wavelength exposures. The matter is explained in terms of the additional capacitance owing to the excess carrier generation within the device under illumination. The photosensitivity modulation of the device can be exploited in photo-sensor or photo-detector applications in various electronic devices.

References

Averin, S. V. , Kuznetzov, P. I. , Zhitov, V. A. , Zakharov, L. Yu. and Kotov, V. M. (2020). MSM-photodetector with ZnSe/ZnS/GaAs Bragg reflector. Opt Quantum Electron. 52: 93:1-7.

Banerjee, A., (2019). Electrical and optoelectronic properties of chemically prepared PbS/MnS Heterojunction. J. Electron. Mater. 48: 438-444.

Chu, C. S., Zhou, Y., Chen, K. J. and Lau, K. M. (2005). Q-Factor Characterization of RF Gan-Based Metal-SemiconductorMetal Planar Interdigitated Varactor. IEEE Electron Device Lett. 26: 432-434.

Ghamsari, M. S., Araghi,M.K. and Farahani, S.J. (2006). The influence of hydrazine hydrate on the photoconductivity of PbS thin film. Mater. Sci. Eng. B. 133: 113-116.

Gunes, S., Fritz, K. P., Neugebauer, H., Sariciftci, N.S., Kumar, S. G. and Scholes, D. (2007). Hybrid solar cells using PbS nanoparticles. Sol. Energy Mater. Sol. Cells. 91: 420-423.

Hirata, H. and Higashiyama, K. (1971) Analytical study of the lead ionselective ceramic membrane electrode. Bull. Chem. Soc. Jpn. 44: 2420-2423.

Khalli, N. A., and Debbar, N. (2019). Performance enhancement of ZnO-based MSM photodiodes by optimizing structure parameters. Int J Numer Model. 32: e2519: 1-10.

Miroshnikova, I. N., Komissarov A. L., and Miroshnikov,B. N. (2010). Noise of Pbsbased semiconductor photoresistors. Meas. Tech. 53: 621-625.

Nouchi, R. (2014). Extraction of the Schottky parameters in metal-semiconductormetal diodes from a single currentvoltage measurement. J. Appl. Phys. 116(184505): 1-6.

Osvald, J., (2015) Back-to-back connected asymmetric Schottky diodes with series resistance as a single diode. Phys. Status Solidi A. 212: 2754–2758.

Pandit, B., Cho, J. (2018). Metalsemiconductor-metal ultraviolet photodiodes based on reduced graphene oxide/GaN Schottky contacts. Thin Solid Films. 660: 824- 827.

Pop, I., Nascu, C., Ionescu, V., Indrea, E. and Bratu, I. (1997). Structural and optical properties of PbS thin films obtained by chemical deposition. Thin Solid Films. 307: 240-244.

Ruzgar, S. and Caglar, M. (2020). Fabrication and characterization of solution processed Al/Sn:ZnO/p-Si photodiodes. Mat. Sci. Semicon. Proc. 115(105076): 1-11.

Seghaier, S., Kamoun, N., Brini, R. and Amara, A. B. (2006). Structural and optical properties of PbS thin films deposited by pulsed laser deposited (PLD) technique at different annealing temperature. Mater. Chem. Phys. 97: 71-80.