The performance analysis of Hydraulic Ram Pump: Influence of specific parameters and validation with Comsol-Multiphysics

Mafidur Rahman; Deva Kanta Rabha; Thuleswar Nath

doi:10.52756/ijerr.2023.v32.019

Mafidur Rahman Research Scholar, Department of Mechanical Engineering, Jorhat Engineering College (under Dibrugarh University), Jorhat-785007, Assam, India; Associate Professor, Department of Mechanical Engineering, Jorhat Engineering College, Jorhat,785007, Assam, India https://orcid.org/0009-0004-8563-5810
Deva Kanta Rabha Associate Professor, Department of Mechanical Engineering, Jorhat Engineering College, Jorhat-785007, Assam, India https://orcid.org/0000-0003-3523-2285
Thuleswar Nath Retd. Professor, Department of Mechanical Engineering, Jorhat Engineering College, Jorhat-785007, India; Principal, Girijananda Chowdhury Institute of Management and Technology, Guwahati, Assam, India https://orcid.org/0000-0002-4058-6670

DOI: https://doi.org/10.52756/ijerr.2023.v32.019

Keywords: Horizontal Distance, Hydram, Pressure Chamber, Waste Valve, Water Hammer, D’ Aubusson, Comsol Multi-Physics

Abstract

Both energy and environmental conservation have been major issues in today’s world. Conventional pumping devices use a huge amount of energy. This gave rise to interest in alternate pumping devices like hydraulic ram pumps. The hydraulic ram pump is capable of pumping water higher than its source with some inlet pressure and velocity head. It works on the principle of the water hammer effect which occurs due to sudden stoppage of flow resulting in the rise in pressure. Since it uses just two moving parts it is mechanically very simple, has very high reliability, minimal maintenance requirements, and long operational life. In rural areas where unconventional energy suffers from various limitations, emphasis is given mainly to the use of unconventional forms of energy. It is designed on the principle of conversion of the potential energy of water into kinetic energy and further conversion into pressure energy to lift water to some desired elevation without the use of electricity, motors, generators or batteries and that is the main advantage for opting this technology. It can operate autonomously, requiring minimal maintenance and having a long lifespan. Additionally, it is a green energy concept, environment-friendly, producing no emissions or pollutants. But, as it runs from the power of water itself in the form of waste water, efficiency is found to be minimal, rendering its limited scope. Hence, it is a need-based approach for maximizing its performance by providing a sustainable and efficient water pumping solution. The vital components of this technology have been detected which play a pivotal role in its performance. These are called influencing parameters. This paper investigates the effect of influencing parameters specifically–the horizontal distance between the pressure chamber and to waste valve (HD) on the performance and the overall efficiency of the Hydraulic ram pump (hydram). Both experimental and simulation studies were done in order to achieve the justification. Five sets of prototypes have been designed and tested individually for experimental and analytical studies. The maximum efficiency comes out to be 79 % with a flow rate of 140 L/hr for optimized HD of 17 cm. The results obtained from the experimental investigation are further simulated with comsol multiphysics for final validation. The experimental study and Comsol multiphysics simulation validate the proposed model and confirm its justification.

References

Asvapoositkul, W., Nimitpaitoon, T., Rattanasuwan, S., & Manakitsirisuthi, P. (2021). Use of hydraulic ram pump for increasing pump head-technical feasibility. Engineering Reports, John Wiley & Sons, 3(5), 1-10. https://doi.org/10.1002/eng2.12314.

Asvapoositkul, W., Juruta, J., Tabtimhin, N., & Limpongsa, Y. (2019). Determination of hydraulic ram pump performance: experimental results. Advances in Civil Engineering, Hindawi Journal, 2019, 9702183. https://doi.org/10.1155//9702183

Bagchi, T.P. (1992). Taguchi methods explained, practical steps to robust design. IITK, Prentice Hall India.

Browne, D. (2005). Design, sizing, construction and maintenance of gravity-fed system in rural areas, module 6: hydraulic ram pump systems, Action Contre la Faim, Hermann, Paris.

Calvert, N.G. (1957) Hydraulic Ram. The engineer.

Deo, A., Pathak, A., Khune, S., & Pawar, M. (2016). Design methodology for hydraulic ram pump. Int. J. Innovative Res. Sci. Eng. Technol., 5(4), 4737-4745. https://doi.org/10.15680/IJIRSET.2016.0504018

Dhaiban, H. T. (2019). Experimental study the performance of ram water pump. Eureka: Physics and Engineering, 1, 22-27. https://doi.org/10.21303/2461-4262.2019.00836

Fatihhi, F.S., Munsyi, M. H., Effendy, M.S., Bakri, A., Zulhaimi, M.Z., & Ismail, Z. (2018). Development and testing of hydraulic ram pump (hydram): experiments and simulations. The International Fundamentum Sciences Symposium IOP Publishing IOP Conf. Series: Materials Science and Engineering, 440, 012032 https://doi.org/10.1088/1757-899X/440/1/012032

Gosline, J.E., Brien, O., & M. P. (1933). The hydraulic ram. University of California Publication in Engineering, 3(1), 1-58. https://doi.org/10.1038/scientificamerican04261873-257

Guo, X., Li, J., Yang, K., Fu, H., Wang, T., Guo, Y., Xia, Q., & Huang, W. (2018). Optimal design and performance analysis of hydraulic ram pump system. Proc. I Mech E Part A: J Power and Energy, 232(7), 841–855. https://doi.org/10.1177/0957650918756761

Harith, M.N., Bakar, R.A., Ramasamy. D., & Quanjin, M. (2017). A significant effect on flow analysis and simulation study of improve design hydraulic pump. 4th International Conference on Mechanical Engineering Research (ICMER2017), IOP Publishing IOP Conf. Series: Materials Science and Engineering, 257(2017), 012076. https://doi.org/10.1088/1757-899X/257/1/012076

Handa, C.C., Valvi,V., Sahar,M., Ingole, P., Samarth,T., Kumbhare,S., Raut, A. (2023). Development of hydraulic ram pump for agriculture uses and approach a review. International Journal for Research in Applied Science & Engineering Technology (IJRASET), 11(5). https://doi.org/10.22214/ijraset.2023.52277

Hussin, N.S.M., Gamil, S.A., Amin, N.A.M., Safar, M.J.A., Majid, M.S.A., Kazim, M.N.F.M., & Nasir, N.F.M. (2017). Design and analysis of hydraulic ram water pumping system. Journal of Physics: Conference Series, J. Phys.: Conf. Ser., 908, 012052. https://doi.org/10.1088/1742-6596/908/1/012052

Inthachot, M., Saehaeng, S., Max, J. F. J., M¨uller, J., & Spreer, W. (2015). Hydraulic ram pumps for irrigation in Northern Thailand. Agriculture and Agricultural Science Procedia, 5, 107–114. https://doi.org/10.1016/j.aaspro.2015.08.015

Johanis, A.L., Mado, R., & Dida, H.P. (2021). Effect of waste valve tuning on hydraulic ram pump efficiency. Proceedings of the 4th International Conference on Applied Science and Technology on Engineering Science - iCAST-ES; Sci Te Press, pp. 237-242. https://doi.org/10.5220/0010943000003260

Krol, J. (1951). The automatic hydraulic ram. Proceedings of the Institution of Mechanical Engineers, 165(1), 53-73.

https://doi.org/10.1243/PIME_PROC_1951_165_011_02

Mado, R., Johanis, A., Mangngi, F., & Budayawati, I. (2021). The effect of pump house layout and compressor tube volume variations on efficiency of 2 inch hydraulic ram pump performance. Proceedings of the 4th International Conference on Applied Science and Technology on Engineering Science, 1, 1127-1132. https://doi.org/10.5220/0010960700003260

Mohammed, N. (2007). Design and construction of a hydraulic ram pump Leonardo Electronic Journal of Practices and Technologies, 11, 59-70.

Phyoe, M.T., Khaing, C.C., & Htun, A. (2019). Design of a hydraulic ram pumping system Iconic Research and Engineering Journals, 3(2), 139-143.

Rajput, R. K. (2002). A textbook of fluid mechanics and hydraulics machines. S. Chand & Company Ltd, New Delhi.

Rajput, R. K. (2019). A textbook of heat and mass transfer, Concise Edition. S. Chand & Company Ltd, New Delhi.

Schiller, E.J., & Kahangire, P. (1984). Analysis and computerized model of the automatic hydraulic ram pump. Canadian Journal of Civil Engineering, 11(4), 743-750. https://doi.org/10.1139/l84-093

Sheikh, S., Handa C., & Ninawe, A.P. (2013). Design Methodology for Hydraulic Ram Pump (HYDRAM). International Journal of Mechanical Engineering & Robotics Research, 2(4), 170-174.

Shamsudeen A. S. (2022). Review of hydraulic ram pumps (hydram) and recommendations for revival. International Journal of Trend in Scientific Research and Development (IJTSRD), 6(6), 1078-1084.

Sarma, D., Das.M., Brahma, B., Pandwar, D., Rongphar, S., & Rahman, M. (2016) Investigation and parameter optimization of a hydraulic ram pump using Taguchi method,Journal of Institution of Engineers (India): Series C, 97(4), 551–559. https://doi.org/10.1007/s40032-016-0295-0

Schiller, E. J. (1986). Practical aspects of hydram operation, Proceedings of a workshop on hydraulic ram pump (hydram) technology. Manuscript Report, International Development Research Centre, Arusha, Tanzania, pp. 1-124.

Shende, P.B., Choudhary, S. K., Ninawe, A.P. (2015). Analysis and enhancement of hydraulic ram pump using computational fluid dynamics, International Journal for Innovative Research in Science & Technology, 2(03), 109-133.

Sutanto, R., Sujita. (2022). Analysis of hydraulic ram pump performance against variation of the inlet elevation above pump. International Journal of Advances in Engineering and Management (IJAEM), 4(8), 682-685.

Suarda, M., Sucipta, M., & Dwijana, G. K. (2019). Investigation on flow pattern in a hydraulic ram pump at various design and setting of its waste valve. IOP Publishing, International Conference on Design, Energy, Materials and Manufacture IOP Conf. Series: Materials Science and Engineering 539, 012008. https://doi.org/10.1088/1757-899X/539/1/012008

Suarda, M., Ghurri, A., Sucipta, M., & Kusuma, G.B.W. (2018). Investigation on characterization of waste valve to optimize the hydraulic ram pump performance. AIP Conference Proceedings, 1984(1), 020023. https://doi.org/10.1063/1.5046607

Yang, K., Li, J., Guo, Y., Guo,X., & Fu, H. (2014). Design and hydraulic performance of a novel hydraulic ram pump, 11th International Conference on Hydro informatics HIC 2014, New York City, USA.

Young, B.W. (l995) Design of hydraulic ram pump systems, in Proceedings of the Institution of Mechanical Engineers, Part A, 209(4), 313–322. https://doi.org/10.1243/PIME_PROC_1995_209_010_01

Young, B.W. (2016). Simplified analysis and design of the hydraulic ram pump. Proceedings of the Institution of Mechanical Engineers, Part A: Journal of Power and Energy, 210(4), 295–303. https://doi.org/10.1243/PIME_PROC_1996_210_048_02